simmill 9W4
High-performance tool system with 12 cutting edges for groove, slot and parting off milling with milling depths up to 16.5 mm!
The system consists of carbide and steel toolholders with internal coolant supply and milling inserts with 12 cutting edges with cutting widths from 0.5 mm and up to 6.0 mm.
Thanks to high-performance toothing technology from Kaestner-Tools, torsion at the insert-holder interface is effectively counteracted and the insert sits very stably in the insert seat. This results in high torques and feeds are possible, a higher cutting performance is achieved and ultimately main times are reduced.
Milling inserts:
The milling inserts are available in cutting widths between 0.5 mm and 6.0 mm and are subdivided as follows:
- Well-proven cutting edge geometry for a wide range of applications, without corner radii, for cutting edge widths:
- 0.5 mm
- 1.0 mm
- GY geometry with staggered teeth with bilateral corner radii for smooth cuts and high surface qualities for cutting edge widths:
- 1.17 mm
- 1.5 mm
- 1.58 mm
- 2.0 mm
- 2.39 mm
- 2.5 mm
- 3.0 mm
- 3.175 mm
- GYY geometry with staggered teeth, a single-sided corner radius and an additional 45° chamfer for a division of the cut and thus less cutting pressure for cutting widths:
- 1.5 mm
- 2.0 mm
- 2.5 mm
- 3.0 mm
- 4.0 mm
- 4.76 mm
- 5.0 mm
- 6.0 mm
- Parting off milling with 6° parting off angle, with and without corner radii, for cutting widths:
- 1.0 mm
- 1.5 mm
- 2.0 mm
Toolholder:
Carbide:
- With internal coolant supply and shank according to DIN 6535 HA
- shank diameters 15.875 mm and 16.0 mm
- L2 dimensions of 60.0 mm / 90.0 mm / 120.0 mm
Steel:
- With internal coolant supply and shank according to DIN 1835 A
- shank diameter 19.05 mm and 20.0 mm
- L2 dimension of 32.0 mm
The system details:
Video
Experience the tool system simmill 9W4 in a short video.
Further simmill product groups:
Solid micro grain carbide milling cutter for groove milling applications in bores as of min. Ø 1,4 mm.
Milling inserts with three or six cutting edges for applications in bores between Ø 10,0 mm and Ø 40,0 mm.
Two edged inserts and milling cutters with up to 20 insert seats for internal machining in bores as of Ø 39 mm.
Groove milling with high precision and stability in bores as of Ø 39,0 mm. With three cutting edges.
Modular tool system including cassettes for using the standard simturn product groups simturn AX and simturn DX as well as compatible adaptors for fine turning heads.